Comparison of Corrosion Rate in the Environment of 10% Acetic Acid solution with different Deflection.

  • Nendi Suhendi Syafei Department of Physics, Faculty of Mathematics and Science (FMIPA), Padjadjaran University, Indonesia
  • S S Rizki Department of Physics, Faculty of Mathematics and Science (FMIPA), Padjadjaran University, Indonesia
  • Suryaningsih Suryaningsih Department of Physics, Faculty of Mathematics and Science (FMIPA), Padjadjaran University, Indonesia
  • Darmawan Hidayat Department of Electrical Engineering Department, Faculty of Mathematics and Science (FMIPA), Padjadjaran University, Indonesia
Keywords: stress corrosion cracking, sweet gas, specimen three-point loading

Abstract

The oil and gas industry exploration that will generally be followed by corrosive substances including sweet gas (eg H2S and CO2), it will result in corrosion event. The corrosion stress cracking will cause the carbon steel pipe to break so that production oil and gas can be stopped. The research aims in this paper is to analyze the corrosion event of carbon steel pipe in laboratory scale on acid environment with the existence of sweet gas H2O and CO2 by using three points loading method. This research uses carbon steel pipe API 5L-X65 which stay in condensation environment of 1350 ml aquades, 150 ml acetic acid. Based on the figure (5.a) and figure (5.b) that the corrosion rate will increase with increasing exposure time, and the greater the stress that is given, the corrosion rate increases according to the image (6.a) and image (6.b). Whereas based on the results of microstructural tests using optical microscopes, pitting corrosion occurs, and corrosion events  occur are the stress corrosion cracking transgranular and intergranular based on figure 8.

 

References

Guaman-Guevara F, Austin H, Hicks N, Streeter R, Austin WEN. Impacts of ocean acidification on intertidal benthic foraminiferal growth and calcification. PloS one. 2019;14(8):e0220046.

Tansel B. Persistence times of refractory materials in landfills: A review of rate limiting conditions by mass transfer and reaction kinetics. Journal of environmental management. 2019;247:88-103.

Chen S, Deng H, Liu G, Zhang D. Corrosion of Q235 Carbon Steel in Seawater Containing Mariprofundus ferrooxydans and Thalassospira sp. Frontiers in microbiology. 2019;10:936.

Shah AA, Kamran M, Bilal S, Ullah R. Cost Effective Chemical Oxidative Synthesis of Soluble and Electroactive Polyaniline Salt and Its Application as Anticorrosive Agent for Steel. Materials. 2019;12(9).

Chong SO, Kim SJ. Effects of Molybdenum on Improvement of Anti-Corrosion by Plasma Ion Nitriding for Austenitic Stainless Steels. Journal of nanoscience and nanotechnology. 2019;19(4):2198-201.

Nendi Suhendi Syafei-Darmawan Hidayat-Emilliano-Liu Kin Men, Analysis Cracking Corrosion on Carbon Steel Pipes API 5LX65 in Solution 7700 ml Aquades, 250 ml Acetic Acid and 50 ml Ammonia with Gas CO2 and H2S in Saturation Condition, , EKSAKTA Vol. 19 Issue 2/30 October 2018, page 22-31.

Yin F, Bao P, Liu X, Yu Y, Wang L, Wang L. Antiparasitic Effect of Copper Alloy Surface on Cryptocaryon irritans in Aquaculture of Larimichthys crocea. Applied and environmental microbiology. 2019;85(3).

Chen J, Mraied H, Cai W. Determining Tribocorrosion Rate and Wear-Corrosion Synergy of Bulk and Thin Film Aluminum Alloys. Journal of visualized experiments : JoVE. 2018(139).

Xu W, Yu F, Yang L, Zhang B, Hou B, Li Y. Accelerated corrosion of 316L stainless steel in simulated body fluids in the presence of H2O2 and albumin. Materials science & engineering C, Materials for biological applications. 2018;92:11-9.

Zhang X, Zhang J, Yu J, Zhang Y, Yu F, Jia L, et al. Enhancement in the photocatalytic antifouling efficiency over cherimoya-like InVO4/BiVO4 with a new vanadium source. Journal of colloid and interface science. 2019;533:358-68.

Li S, Hou B, Dai D, Shu S, Wu M, Li A, et al. CVD Synthesis of Monodisperse Graphene/Cu Microparticles with High Corrosion Resistance in Cu Etchant. Materials. 2018;11(8).

Moura V, Ribeiro I, Moriggi P, Capao A, Salles C, Bitati S, et al. The influence of surface microbial diversity and succession on microbiologically influenced corrosion of steel in a simulated marine environment. Archives of microbiology. 2018;200(10):1447-56.

Cui K, Sun S, Xiao M, Liu T, Xu Q, Dong H, et al. Microbial Mineralization of Montmorillonite in Low-Permeability Oil Reservoirs for Microbial Enhanced Oil Recovery. Applied and environmental microbiology. 2018;84(14).

Nendi Suhendi Syafei, Darmawan Hidayat , Bernard Y Tumbeleka , Liu Kin Men, IN Crack Due To Phenomena Corrosion Stress Cracking Of Steel Pipe Carbon Api 5l-X65 In Asetic Acid Solution With Completed Gas Co2 And H2s In Saturation Condition, J. Nat. Scien. & Math. Res. Vol. 4 No.2 (2018) 96-101, 97.

Syafei, N.S., Hidayat, D., Emlliano, Men, L.K, Comparison of Voltage Crack Corrosion Rate in Carbon Steel Pipes in Acetic Acid and Sea Water with Sweet Gas,Proceedings of the National Seminar on Innovation and Application of Technology in Industry, ITN Malang, volume 5 nomer 4, page 133-141, 2 february 2019, ISSN 2085-4218.

N S Syafei, D Hidayat , Emlliano, L K Men, Events of Corrosion Phenomena on Carbon Steel Pipes in Environment of Sea Water and Ammonia Solutions due to the Presence of Sweet Gas, EKSAKTA Vol. 20 Issue 1/30 April 2019, E-ISSN : 2549-7464, P-ISSN : 1411-3724, page 86-99.

Nendi Suhendi Syafei, Darmawan Hidayat , Emilliano, Liu Kin Men, Analysis Cracking Corrosion on Carbon Steel Pipes API 5LX65 in Solution 7700 ml Aquades, 250 ml Acetic Acid and 50 ml Ammonia with Gas CO2 and H2S in Saturation Condition, EKSAKTA Vol. 19 Issue 2/30 October 2018, page 22-31.

Nendi Suhendi Syafei, Darmawan Hidayat, Bernard Y Tumbelaka, Liu Kin Men, Analysis of Strain Strain Corrosion Analysis on Fire Carbon Steel Pipes 5L-X65 in a Solution of 7900 ml of Sea Water and 100 ml of Ammonia with CO2 and H2S Gas in Saturated State , National Seminar on Innovation and Application of Technology in Industry 2018, ISSN 2085-4218 ITN Malang, February 3, 2018, p.38-46).

Nendi Suhendi Syafei-Darmawan Hidayat-Bernard Y Tumbelaka-Muhammad taufik. (May 9, 2017), "Characteristics of API 5L-X65 Carbon Steel Pipe with Three-Point Imposition Method on H2S Gas Environment CO2 Saturated Condition in Acetic Acid Solution", Proceedings of the National Seminar on Energy and Technology (Synergy) Unisma Bekasi, p.33-39 , ISSN: 2527-3108.

Rizki S S C, “Analysis Of Tension Voltage On Api 5l X65 Carbon Type Towards Corrosion Rate In Glacial Acetic Acid Solution And Sea Water”, essay, physics study program, faculty of mathematics and natural sciences, padjadjaran university, 2019.

Syafei, N.S.- Hidayat, D.- Emlliano-Men, L.K., Cross Corrosion Rate In Acid And Basic Solutions With Gas Sweet In The Carbon Steel Pipes With The Same Deflection, Proceedings of the National Seminar on Energy and Technology (Sinergy) Unisma Bekasi, volume 4, p.17-25 , 19 juni 2019, ISSN: 2527-3108.

Published
2019-08-31
How to Cite
1.
Syafei N, Rizki S, Suryaningsih S, Hidayat D. Comparison of Corrosion Rate in the Environment of 10% Acetic Acid solution with different Deflection. EKSAKTA [Internet]. 31Aug.2019 [cited 20Nov.2019];20(2):84-3. Available from: http://eksakta.ppj.unp.ac.id/index.php/eksakta/article/view/190

Most read articles by the same author(s)

Obs.: This plugin requires at least one statistics/report plugin to be enabled. If your statistics plugins provide more than one metric then please also select a main metric on the admin's site settings page and/or on the journal manager's settings pages.